您好,歡迎訪問上海現易電子元器件有限公司網站!
printf()函數可以直接向窗口格式化輸出,給我們調試程序帶來很大的方便,然而在Keil MDK環境下直接使用printf()函數就會陷入軟件中斷,導致死循環的產生;因而不能進入main()函數。
單步調試程序時會發現程序指針一直在 SWI_Handler B SWI_Handler 打轉;
解決方法:
工程選擇NXP的LPC21XX器件。
1.首先在Keil安裝目錄下面ARM——Startup找到Retarget.c文件將其復制到你的工程文件夾下面;并將其加入到工程中;
2. 在Keil安裝目錄下面ARM——Examples——Hello找到Serial.c文件將其復制到你的工程文件夾下面;并將其加入到工程中;
3.Serial.c代碼如下:
/******************************************************************************/
/* SERIAL.C: Low Level Serial Routines */
/******************************************************************************/
/* This file is part of the uVision/ARM development tools. */
/* Copyright (c) 2005-2006 Keil Software. All rights reserved. */
/* This software may only be used under the terms of a valid, current, */
/* end user licence from KEIL for a compatible version of KEIL software */
/* development tools. Nothing else gives you the right to use this software. */
/******************************************************************************/
#include
#define CR 0x0D
void init_serial (void) { /* Initialize Serial Interface */
PINSEL0 = 0x00050000; /* Enable RxD1 and TxD1 */
U1LCR = 0x83; /* 8 bits, no Parity, 1 Stop bit */
U1DLL = 97; /* 9600 Baud Rate @ 15MHz VPB Clock */
U1LCR = 0x03; /* DLAB = 0 */
}
/* implementation of putchar (also used by printf function to output data) */
int sendchar (int ch) { /* Write character to Serial Port */
if (ch == '\n') {
while (!(U1LSR & 0x20));
U1THR = CR; /* output CR */
}
while (!(U1LSR & 0x20));
return (U1THR = ch);
}
int getkey (void) { /* Read character from Serial Port */
while (!(U1LSR & 0x01));
return (U1RBR);
}
4.在頭文件中加入#include
5.在使用printf函數之前對串口進行初始化;可以直接使用Serial.c中的 init_serial ()函數對串口初始化。
上海現易電子元器件有限公司 版權所有 未經授權禁止復制或鏡像
CopyRight 2020-2025 www.urqm.cn All rights reserved 滬ICP備2020031792號